Product Description

Splash-resistant inline holders for adding mini blade-fuse protection to 12-volt accessory circuits. Each holder uses 14 AWG leads and is supplied with a fuse according to the listing.

Key Features

• 14 AWG inline lead construction
• For mini blade fuses
• Supplier-listed 12 V DC, 20 A holding, and 30 A maximum ratings
• Available in 5- or 10-piece packs

Vehicle Compatibility

Universal electrical component; verify fuse type, wire gauge, current draw, environment, and circuit voltage for the intended installation.

Application Note

Install the holder as close as practical to the circuits power source, select the fuse for the wire and load, crimp or solder with approved connectors, and seal all joints.

Safety Note

Disconnect power before installation. Never exceed the smallest rating in the circuit, substitute an oversized fuse, or place the holder where heat, abrasion, fuel, or water can damage it.

Independent Reseller Notice

Parts Island independently resells this product and is not its manufacturer unless the listing expressly states otherwise. Any company, brand, product, vehicle, or model names shown or referenced are used only to identify the product, design, or compatibility. All third-party marks remain the property of their respective owners.